Keeping a router’s firmware updated on time is very crucial for any networking device. Updating the firmware not only enhances the productivity of the device, but it also keeps your network secure from the latest threats. But, some users are don’t know how to update router firmware and due to this users experience the several types of network and malware-related issue in their device. If you are also unaware about the procedure then you don’t need to worry because you are in right place. In this article we will provide a firmware update guide. We recommend you don’t skip the reading. Otherwise you are not able to update the device in hassle free manner. So, let’s start without more delay!

Steps to Update Netgear Router Firmware

In this section we cover the entire important step related to manual method to update the firmware of the device. All the steps are very easy to perform you just need to read them carefully.

Power on the Router

The foremost thing you need to do is give the sufficient power supply to the router. To do this you need to plug the router in non-damaged wall outlet. Ensure that power source gives the fluctuation free electricity.

Once the router is plugged in press the turn-on button.

Now your Netgear router is booted up for the next step.

Connect Router and Modem

Now, you need to connect the both the devices router and host router with strong connection. You have two mode of connection wireless and wired. It depends on you which one you use.

We recommend you use the wires connection because it seen that Ethernet cable supplies the accurate network and reduce the chances of disconnection between the devices.

However, if you go with wireless connection, then make sure both the device place at the suitable places where they communicate properly in order to signal transmission.

Switch on the Computer Or Laptop

For the nest step you need to turn-on the computer or laptop. You can use any one of them according to which one you have. To power up the computer you need to plug it into the good condition wall outlet. Thereafter, press the start button. Moreover, you can use the UPS in order to give the power back in case of power cut.

Open Internet Browser

Launch the web browser in you computer. You can use any web browser to access the default web address. You just need to endure that internet browser is updated because old browser not working properly.

In addition, keep the browser clean from the extra files like cache and cookies. All the extra files should be deleted from the router for the best out comes.

Access the Default Web Address

It’s time to access the routerlogin.net admin for the further process. To do this you need to type the URL into the address bar of the browser carefully without making typing mistake. After that, Press the Enter key.

Log Into the Netgear Router

Now you will see the login page in which you need to fill the credential and click on the Log In button.

The Netgear router dashboard will appear, in which you need to perform some sub steps:

• Go to the Menu Settings.

• Click on the Advance Settings.

• Select the Administration > Update Firmware

• Follow the on screen prompts to complete the firmware update.

This is how you can update router firmware through manual method.

Conclusion,

Now you know all the important steps to update the firmware of Netgear router via manual method. Once the firmware is update, then your device gives the top-notch performance.